Please wait while the page loads...

What could cause the check engine light to come on in a 2013 Jeep Cherokee?

When your check engine light comes on, this could be as straightforward as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a precarious problem that could cause precarious damage to your engine and come with a generous repair bill. Depending on your make and model, the check engine light will illuminate or blink. A dependable glow frequently means something less precarious but a flashing check engine light indicates that your vehicle’s engine is in precarious trouble and service is necessary abruptly. If your check engine light is flashing in your 2013 Jeep Cherokee, we highly recommend not to drive the vehicle and schedule Jeep service today. Below is a list of the most receptive reasons your check engine light can come on:

  • New Spark Plugs or Plug Wires are essential for your 2013 Jeep Cherokee. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your automobile. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or departed, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, fundamental to more expensive repairs.
  • One of the most commonplace and frequent cause is that your 2013 Jeep Cherokee gas cap is loose, damaged or missing. The gas cap for your 2013 Jeep Cherokee serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is departed or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on straightaway after you put gas in your 2013 Jeep Cherokee, initial thing you should check is to make convinced the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Jeep Cherokee is what determines how much fuel is essential to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to vital changes, like altitude. If your Jeep Cherokee is having trouble starting, idling rough or has a sudden change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or other item can wreak havoc on your 2013 Jeep Cherokee if it’s not installed accurately. These aftermarket parts and accessories can dump the battery, trigger the check engine light, or even avoid the automobile from starting. If these issues sound simple, bring your Cherokee to Jeep and have our team of certified mechanics ensure that your aftermarket items were installed well and aren't causing any issue. Getting accessories, especially aftermarket parts and accessories, or using OEM parts initial place might rate a small bit more but could save you money from having to get poor work and damage caused by poor installation work corrected.
  • The battery is low or dead. The battery in your 2013 Jeep Cherokee is every vital. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did many decades ago, and they don't really require maintenance. The estimate of a new one depends on the type of Jeep you drive, but check our present service coupons and specials.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, known as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your automobile will be fewer accessible when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2013 Jeep Cherokee's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to hint the noble mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2013 Jeep Cherokee’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is usually caused by neglected maintenance, which is why Crown Chrysler Dodge Jeep Ram Greensboro offers a complimentary multi-point inspection with every Jeep service. If you have an issue with your catalytic converter and don't get it repaired, your 2013 Jeep Cherokee will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause other problems from overheating.
  • Your 2013 Jeep Cherokee has a vacuum leak. Every Jeep Cherokee has a vacuum system that performs a wide variety of functions. The vacuum system also helps lower bad emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can barren out and crack, especially if they’re exposed to imposing heat or extreme cold.

Is it safe to drive your 2013 Jeep Cherokee with the check engine light on?

If the check engine light is shining, this means that there is a unhealthy issue and it is recommended to service your Jeep Cherokee instantly. This question is not very accessible because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be reliable to drive. This is often indicated by a steady glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more risky problem. Call the experts at Crown Chrysler Dodge Jeep Ram Greensboro by dialing 3368951348 so you can describe the issues. Or lower your speed and bring your 2013 Jeep to our certified mechanics as soon as possible.

How much does it cost to get the engine light checked?

The central value for a check engine light diagnosis & testing is typically between $88 and $111. The numerous news, Crown Chrysler Dodge Jeep Ram Greensboro offers complimentary multi-point inspections and free diagnostics, in most cases, to help mean the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not appropriately tightened to a more competent failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it numerous to get the reasonable code reading and diagnosis.

Will the check engine light reset itself?

The check engine light on your 2013 Jeep Cherokee will usually shut itself off if the issue or code that caused it to turn on is repaired. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going cooperative, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2013 Jeep Cherokee light will go off after about 20-40 miles. If you commute over that amount and the light is still on, you will need to bring it in to Crown Chrysler Dodge Jeep Ram Greensboro so the light and code can be double-checked and reset.

2013 Jeep Cherokee Check Engine Light

A flashing light hints that the problem is unhealthy and if not taken care of immediately may result in major damage to the vehicle. If the check engine light in your 2013 Jeep Cherokee starts flashing, that means that the problem needs abrupt attention and your Jeep should be brought in immediately. This blinking light usually indicates a relentless engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can now enhance the temperature of the catalytic converter to a point where damage is likely, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can strictly be the cause. A detrimental, former or dirty spark plug can cause the engine to misfire. If your check engine light is flashing, please contact our company of automotive experts at Crown Chrysler Dodge Jeep Ram Greensboro immediately by calling 3368951348. If the problem is ignored or you continue to commute, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very expensive repair.

How many miles can you drive with the check engine light?

The safest bet is to decipher the code and then plan your strategy accordingly. Since each check engine code has its own level of severity, it is hard to predict how frequent miles you can drive with the warning light on. It could be anything from a bad sensor to plug wires needing to be interchanged. If you check engine light is shining, we pick that you pull over and contact Crown Chrysler Dodge Jeep Ram Greensboro to aid illustrate if your vehicle is capable to drive in or if we pick a tow truck.

2013 Jeep Cherokee Check Engine Light Flashing

Although there are bountiful feasible causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are fantastic established causes consisting something as plain as a loose gas cap. Substitute established reasons for a Check Engine Light are damaged oxygen sensor, faulty head gasket, faulty emissions control part, a malfunction with the fuel injection system, dirty mass airflow sensor, or defective spark plugs to name a lot. No matter what is the root cause of the Check Engine Light, we have the Jeep Certified Technicians and the certified service protocol to isolate the root problem and repair it as necessary to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Jeep issue was fixed.

Every 2013 Jeep Cherokee was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its laborious systems. The sensors are continually detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what absolutely is wrong nor what to do about it. That’s where we come in; Crown Chrysler Dodge Jeep Ram Greensboro provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Immensely Qualified Service skilled.

Check Engine Light Service 2013 Jeep Cherokee

What do you do when you’re driving along in your Jeep Cherokee and suddenly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Jeep owners, your heart sinks a microscopic because you have microscopic idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the price of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the vehicle over to the side of the road and call a tow truck, but it is recommended that you get your 2013 Jeep Cherokee checked as soon as viable. Ignoring that warning could end up causing big wear and tear to expensive engine components.

When your 2013 Jeep Cherokee's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electrical control system that it can’t sufficient, a computer turns on your check engine light. This amber or yellow light is commonly labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is learn with an electronic analyze tool that is used by our Jeep auto repair mechanics at Crown Chrysler Dodge Jeep Ram Greensboro. There are also a number of relatively economical code readers that are designed for do-it-yourselfers, should you opt for that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an trained high-tech to find out the issue and repair it.

What Does the Check Engine Light Mean?

One of the most typically misunderstood lights or indicators in your 2013 Jeep Cherokee is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few different ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your automobile. Onboard computers increasingly have controlled and monitored automobile performance since the 80s and do a variety of things for your 2013 Jeep Cherokee. Some of these include shifting automatic transmissions ignition timing, controlling engine speed, and implementing stability control, just to name a few. With that being said, the check engine light can mean a collection of alternative things. It can be as commonplace as your gas cap being loose or as significant as engine knocking. If your check engine light is on in your 2013 Jeep Cherokee, contact Crown Chrysler Dodge Jeep Ram Greensboro. Our Jeep service department can help you find out what code is turning your check engine light on or diagnose why your check engine light is flashing. Contact Crown Chrysler Dodge Jeep Ram Greensboro today!

2013 Jeep Cherokee Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that microscopic light on your vehicle’s dashboard suddenly illuminates, but in reality, it is not something that should cause you to shut down in fear polite away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your Cherokee. There are hundreds of divergent codes that your check engine light can express. While that sounds daunting, with a microscopic patience, tackling important diagnostics will give you humane knowledge about your vehicle and will also allow that Check Engine Light to do what it is absolutely supposed to do: be your guide. Unfortunately, feasible and common vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of correct OBD codes, there are also hundreds of correct reasons for the light, including:

  • Loose Gas Cap or Missing Gas Cap
  • Computer output circuit issues
  • Ignition system faults
  • Transmission issues
  • Emissions controls issues
  • Bad Spark Plugs
  • Fuel and air metering systems problems
  • Old Battery
  • O2 Sensor

This is why it is intense for someone who does not have frequent of automotive knowledge to not assume what a code means. If the engine light comes on due to a applicable concern, you risk damaging your car further by not repairing the issue honest away. Call Crown Chrysler Dodge Jeep Ram Greensboro at 3368951348 today or schedule your check engine light service online today! When your check engine light comes on, you should get it checked out instantly by a certified Jeep mechanic.