Please wait while the page loads...

2014 Chrysler 300 Check Engine Light

A flashing light indicates that the problem is perilous and if not taken care of immediately may result in broad damage to the vehicle. If the check engine light in your 2014 Chrysler 300 starts flashing, that means that the problem needs speedy attention and your Chrysler should be brought in immediately. This blinking light ordinarily suggests a strict engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can hastily raise the temperature of the catalytic converter to a point where damage is feasible, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can absolutely be the cause. A bad, common or dirty spark plug can cause the engine to misfire. If your check engine light is flashing, please contact our department of automotive veterans at Crown Chrysler Dodge Jeep Ram Greensboro instantly by calling 3368951348. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a greatly fancy repair.

Is it safe to drive your 2014 Chrysler 300 with the check engine light on?

This question is not very easy because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to commute. This is typically indicated by a steady glow of the check engine light. If you notice a difference in the performance of the car, it could be an indication of a more relentless problem. If the check engine light is shining, this means that there is a relentless issue and it is recommended to service your Chrysler 300 instantly. Call the experts at Crown Chrysler Dodge Jeep Ram Greensboro by dialing 3368951348 so you can describe the issues. Or reduce your speed and bring your 2014 Chrysler to our certified mechanics as soon as potential.

Check Engine Light Service 2014 Chrysler 300

What do you do when you’re driving along in your Chrysler 300 and hastily, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Chrysler owners, your heart sinks a tiny because you have tiny idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the estimate of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2014 Chrysler 300 checked as soon as positive. Ignoring that warning could end up causing major damage to expensive engine components.

When your 2014 Chrysler 300's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t correct, a computer turns on your check engine light. This amber or yellow light is often labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electronic scan tool that is used by our Chrysler auto repair mechanics at Crown Chrysler Dodge Jeep Ram Greensboro. There are also a number of relatively inexpensive code readers that are designed for do-it-yourselfers, should you opt for that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced technological to opt for the issue and repair it.

How much does it cost to get the engine light checked?

The check engine light warns of issues ranging from a gas cap that's not properly tightened to a more risky failure like a intrusive catalytic converter or a problem with one of the car's oxygen sensors, so it alluring to get the advantageous code reading and diagnosis. The average cost for a check engine light diagnosis & testing is continually between $88 and $111. The alluring news, Crown Chrysler Dodge Jeep Ram Greensboro offers complimentary multi-point inspections and free diagnostics, in most cases, to help read the cause of your check engine light.

How many miles can you drive with the check engine light?

It could be anything from a damaging sensor to plug wires needing to be replaced. The safest bet is to decipher the code and then plan your strategy subsequently. Since every check engine code has its own level of severity, it is laborious to predict how copious miles you can drive with the warning light on. If you check engine light is flashing, we advise that you pull over and contact Crown Chrysler Dodge Jeep Ram Greensboro to help find out if your car is safe to drive in or if we advise a tow truck.

2014 Chrysler 300 Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard suddenly illuminates, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also admitted as the OBD (on-board computer diagnostic system) in your 300. There are hundreds of explicit codes that your check engine light can represent. While that sounds daunting, with a little patience, tackling accessible diagnostics will give you incredible knowledge about your vehicle and will also allow that Check Engine Light to do what it is really supposed to do: be your guide. Unfortunately, noticeable and functional vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of feasible OBD codes, there are also hundreds of feasible reasons for the light, including:

  • Old Battery
  • Bad Spark Plugs
  • Transmission issues
  • Emissions controls issues
  • Ignition system faults
  • Loose Gas Cap or Missing Gas Cap
  • Computer output circuit issues
  • Fuel and air metering systems problems
  • O2 Sensor

This is why it is hard for someone who does not have a lot of automotive knowledge to not assume what a code means. Call Crown Chrysler Dodge Jeep Ram Greensboro at 3368951348 today or schedule your check engine light service online today! If the engine light comes on due to a precarious concern, you risk destructive your car further by not repairing the issue right away. When your check engine light comes on, you should get it checked out hastily by a certified Chrysler mechanic.

What could cause the check engine light to come on in a 2014 Chrysler 300?

When your check engine light comes on, this could be as uncomplicated as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a serious problem that could cause serious damage to your engine and come with a important repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady glow commonly means something less serious but a flashing check engine light illustrates that your vehicle’s engine is in serious trouble and service is fundamental promptly. If your check engine light is flashing in your 2014 Chrysler 300, we extremely recommend not to drive the vehicle and schedule Chrysler service at this moment. Below is a list of the most natural reasons your check engine light can come on:

  • One of the most prevailing and frequent cause is that your 2014 Chrysler 300 gas cap is loose, damaged or missing. The gas cap for your 2014 Chrysler 300 serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a harmful fuel cap? If your gas cap is classical or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't fancy. If your check engine light turns on rapidly after you put gas in your 2014 Chrysler 300, initial thing you should check is to make satisfied the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Chrysler 300 is what determines how much fuel is needed to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to individual changes, like altitude. If your Chrysler 300 is having trouble starting, idling rough or has a speedy change in the position of the throttle pedal, this could be a sign of a harmful mass airflow sensor.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or definite item can wreak havoc on your 2014 Chrysler 300 if it’s not installed properly. These aftermarket parts and accessories can deposit the battery, trigger the check engine light, or even avert the vehicle from starting. If these issues sound prevailing, bring your 300 to Chrysler and have our team of certified mechanics ensure that your aftermarket items were installed properly and aren't causing any issue. Getting accessories, extraordinarily aftermarket parts and accessories, or using OEM parts initial place might cost a tiny bit more but could save you money from having to get poor work and break caused by poor installation work corrected.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, prevailing as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less normal when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause break to your catalytic converter and your 2014 Chrysler 300's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to determine the right variety of air and fuel that enters the cylinders in your engine. A harmful O2 sensor can also cause a car to fail an emissions test.
  • Your 2014 Chrysler 300 has a vacuum leak. Every Chrysler 300 has a vacuum system that performs a wide variety of functions. The vacuum system also helps lower harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can arid out and crack, extraordinarily if they’re exposed to important heat or extreme pleasant.
  • The battery is low or dead. The battery in your 2014 Chrysler 300 is every alarming. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a few decades ago, and they don't really require maintenance. The price of a new one depends on the type of Chrysler you drive, but check our present service coupons and specials.
  • New Spark Plugs or Plug Wires are needed for your 2014 Chrysler 300. The spark plugs are the part of your engine that ignites the air/fuel variety in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are harmful or classical, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or break to ignition coils and O2 sensors, principal to more fancy repairs.
  • Your catalytic converter is harmful or going harmful. The catalytic converter is a part of your 2014 Chrysler 300’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is commonly caused by neglected maintenance, which is why Crown Chrysler Dodge Jeep Ram Greensboro offers a complimentary multi-point inspection with every Chrysler service. If you have an issue with your catalytic converter and don't get it repaired, your 2014 Chrysler 300 will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause definite problems from overheating.

What Does the Check Engine Light Mean?

One of the most naturally misunderstood lights or indicators in your 2014 Chrysler 300 is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few different ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your 2014 Chrysler 300. Some of these include controlling engine speed, ignition timing, shifting automatic transmissions and implementing stability control, just to name a lot. With that being said, the check engine light can indicate a variety of additional things. It can be as pure as your gas cap being loose or as risky as engine knocking. If your check engine light is on in your 2014 Chrysler 300, contact Crown Chrysler Dodge Jeep Ram Greensboro. Our Chrysler service department can help you learn what code is turning your check engine light on or diagnose why your check engine light is flashing. Contact Crown Chrysler Dodge Jeep Ram Greensboro today!

Will the check engine light reset itself?

The check engine light on your 2014 Chrysler 300 will regularly shut itself off if the issue or code that caused it to turn on is serviced. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going functional, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2014 Chrysler 300 light will go off after about 20-40 miles. If you commute over that amount and the light is still on, you will need to bring it in to Crown Chrysler Dodge Jeep Ram Greensboro so the light and code can be double-checked and reset.

2014 Chrysler 300 Check Engine Light Flashing

Although there are countless conceivable causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are several commonplace causes comprising something as easy as a loose gas cap. Different commonplace reasons for a Check Engine Light are faulty head gasket, a malfunction with the fuel injection system, dirty mass airflow sensor, damaged oxygen sensor, faulty emissions control part, or defective spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Chrysler Certified Mechanics and the certified service protocol to isolate the root problem and repair it as needed to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Chrysler issue was fixed.

Every 2014 Chrysler 300 was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its necessary systems. The sensors are continually detecting conditions while sending data to the electronic control department. If the electronic control department detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is wrong nor what to do about it. That’s where we come in; Crown Chrysler Dodge Jeep Ram Greensboro provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Remarkably Qualified Service professional.