Please wait while the page loads...

2014 Chrysler Town and Country Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard rapidly illuminates, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your Town and Country. There are hundreds of alternative codes that your check engine light can mean. While that sounds daunting, with a little patience, tackling decisive diagnostics will give you accessible knowledge about your vehicle and will also allow that Check Engine Light to do what it is actually supposed to do: be your guide. Unfortunately, intelligent and accurate vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of likely OBD codes, there are also hundreds of likely reasons for the light, including:

  • Fuel and air metering systems problems
  • Bad Spark Plugs
  • Ignition system faults
  • Old Battery
  • O2 Sensor
  • Transmission issues
  • Loose Gas Cap or Missing Gas Cap
  • Emissions controls issues
  • Computer output circuit issues

This is why it is big for someone who does not have a lot of automotive knowledge to not assume what a code means. When your check engine light comes on, you should get it checked out immediately by a certified Chrysler mechanic. If the engine light comes on due to a critical concern, you risk intrusive your car additional by not repairing the issue right away. Call Crown Chrysler Dodge Jeep Ram Greensboro at 3368951348 today or schedule your check engine light service online today!

Will the check engine light reset itself?

The check engine light on your 2014 Chrysler Town and Country will normally shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going exact, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2014 Chrysler Town and Country light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to bring it in to Crown Chrysler Dodge Jeep Ram Greensboro so the light and code can be double-checked and reset.

Is it safe to drive your 2014 Chrysler Town and Country with the check engine light on?

This question is not particularly distinct because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to drive. This is frequently indicated by a steady glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more contrasting problem. If the check engine light is blinking, this means that there is a contrasting issue and it is recommended to service your Chrysler Town and Country now. Call the specialists at Crown Chrysler Dodge Jeep Ram Greensboro by dialing 3368951348 so you can describe the issues. Or reduce your speed and deliver your 2014 Chrysler to our certified mechanics as soon as viable.

2014 Chrysler Town and Country Check Engine Light

A shining light suggests that the problem is threatening and if not taken care of now may result in broad damage to the vehicle. If the check engine light in your 2014 Chrysler Town and Country starts shining, that means that the problem needs immediate attention and your Chrysler should be transported in now. This blinking light usually suggests a draconian engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can swiftly expand the temperature of the catalytic converter to a point where damage is feasible, requiring an lavish repair. Some owners ask if spark plugs cause the check engine light to flash? This can absolutely be the cause. A bad, old or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a excessively expensive repair. If your check engine light is glaring, please contact our team of automotive experts at Crown Chrysler Dodge Jeep Ram Greensboro hastily by calling 3368951348.

What could cause the check engine light to come on in a 2014 Chrysler Town and Country?

When your check engine light comes on, this could be as simple as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a hazardous problem that could cause hazardous damage to your engine and come with a considerable repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady glow commonly means something less hazardous but a glaring check engine light expresses that your vehicle’s engine is in hazardous trouble and service is needed now. If your check engine light is glaring in your 2014 Chrysler Town and Country, we exceptionally advise not to drive the vehicle and schedule Chrysler service today. Below is a list of the most simple reasons your check engine light can come on:

  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2014 Chrysler Town and Country’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is commonly caused by neglected maintenance, which is why Crown Chrysler Dodge Jeep Ram Greensboro offers a complimentary multi-point inspection with every Chrysler service. If you have an issue with your catalytic converter and don't get it repaired, your 2014 Chrysler Town and Country will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause substitute problems from overheating.
  • Your O2 Sensor (Oxygen Sensor) needs to be changed. The Oxygen sensor, acknowledged as the O2 sensor, measures the payment of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less sane when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2014 Chrysler Town and Country's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to choose the right range of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or substitute item can wreak havoc on your 2014 Chrysler Town and Country if it’s not installed subsequently. These aftermarket parts and accessories can discharge the battery, trigger the check engine light, or even prevent the vehicle from starting. If these issues sound present, bring your Town and Country to Chrysler and have our team of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, especially aftermarket parts and accessories, or using OEM parts first place might value a little bit more but could save you money from having to get poor work and damage caused by poor installation work corrected.
  • The battery is low or dead. The battery in your 2014 Chrysler Town and Country is every crucial. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did assorted decades ago, and they don't really require maintenance. The price of a new one depends on the type of Chrysler you drive, but check our actual service coupons and specials.
  • One of the most friendly and frequent cause is that your 2014 Chrysler Town and Country gas cap is loose, damaged or missing. The gas cap for your 2014 Chrysler Town and Country serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is old or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on hastily after you put gas in your 2014 Chrysler Town and Country, first thing you should check is to make bold the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your 2014 Chrysler Town and Country has a vacuum leak. Every Chrysler Town and Country has a vacuum system that performs a wide variety of functions. The vacuum system also helps reduce harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can barren out and crack, especially if they’re exposed to intense heat or extreme bleak.
  • Your mass airflow sensor (known as MAF) needs to be changed. The mass airflow sensor in your Chrysler Town and Country is what determines how much fuel is decisive to run your engine efficiently by measuring the payment of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to actual changes, like altitude. If your Chrysler Town and Country is having trouble starting, idling rough or has a sudden change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • New Spark Plugs or Plug Wires are decisive for your 2014 Chrysler Town and Country. The spark plugs are the part of your engine that ignites the air/fuel range in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or old, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, best to more expensive repairs.

2014 Chrysler Town and Country Check Engine Light Flashing

Although there are countless capacity causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are several prevailing causes including something as commonplace as a loose gas cap. Back-up prevailing reasons for a Check Engine Light are faulty head gasket, faulty emissions control part, dirty mass airflow sensor, damaged oxygen sensor, a malfunction with the fuel injection system, or defective spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Chrysler Certified Technicians and the certified service protocol to isolate the root problem and repair it as needed to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Chrysler issue was repaired.

Every 2014 Chrysler Town and Country was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its crucial systems. The sensors are continually detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what actually is liable nor what to do about it. That’s where we come in; Crown Chrysler Dodge Jeep Ram Greensboro provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Immensely Qualified Service professional.

How much does it cost to get the engine light checked?

The average cost for a check engine light diagnosis & testing is typically between $88 and $111. The common news, Crown Chrysler Dodge Jeep Ram Greensboro offers complimentary multi-point inspections and free diagnostics, in most cases, to help elect for the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not properly tightened to a more unstable failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it common to get the natural code reading and diagnosis.

What Does the Check Engine Light Mean?

One of the most commonly misunderstood lights or indicators in your 2014 Chrysler Town and Country is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in assorted discernable ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a mixture of things for your 2014 Chrysler Town and Country. Some of these include controlling engine speed, shifting automatic transmissions ignition timing, and implementing stability control, just to name several. With that being said, the check engine light can mean a variety of odd things. It can be as uncomplicated as your gas cap being loose or as perilous as engine knocking. If your check engine light is on in your 2014 Chrysler Town and Country, contact Crown Chrysler Dodge Jeep Ram Greensboro. Contact Crown Chrysler Dodge Jeep Ram Greensboro today! Our Chrysler service department can help you find out what code is turning your check engine light on or diagnose why your check engine light is flashing.

How many miles can you drive with the check engine light?

If you check engine light is flashing, we recommend that you pull over and contact Crown Chrysler Dodge Jeep Ram Greensboro to help choose if your vehicle is safe to drive in or if we recommend a tow truck. The safest bet is to decipher the code and then plan your strategy appropriately. Since any check engine code has its own level of severity, it is difficult to predict how various miles you can drive with the warning light on. It could be anything from a bad sensor to plug wires needing to be replaced.

Check Engine Light Service 2014 Chrysler Town and Country

What do you do when you’re driving along in your Chrysler Town and Country and suddenly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Chrysler owners, your heart sinks a little because you have little idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2014 Chrysler Town and Country checked as soon as feasible. Ignoring that warning could end up causing major damage to expensive engine components.

When your 2014 Chrysler Town and Country's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t appropriate, a computer turns on your check engine light. This amber or yellow light is mostly labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is find out with an mechanical investigate tool that is used by our Chrysler auto repair mechanics at Crown Chrysler Dodge Jeep Ram Greensboro. There are also a number of relatively economical code readers that are designed for do-it-yourselfers, should you prefer that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an active professional to select the issue and repair it.