Please wait while the page loads...

Will the check engine light reset itself?

The check engine light on your 2014 Ram 2500 will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going convenient, and you did countless of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2014 Ram 2500 light will go off after about 20-40 miles. If you travel to work over that payment and the light is still on, you will need to bring it in to Crown Chrysler Dodge Jeep Ram Greensboro so the light and code can be double-checked and reset.

2014 Ram 2500 Check Engine Light Flashing

Although there are countless capacity causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are a few regular causes including something as accepted as a loose gas cap. Alternative regular reasons for a Check Engine Light are damaged oxygen sensor, dirty mass airflow sensor, faulty emissions control part, faulty head gasket, a malfunction with the fuel injection system, or defective spark plugs to name assorted. No matter what is the root cause of the Check Engine Light, we have the Ram Certified Technicians and the certified service protocol to isolate the root problem and repair it as needed to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Ram issue was fixed.

Every 2014 Ram 2500 was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its cheerful systems. The sensors are naturally detecting conditions while sending data to the electrical control department. If the electrical control department detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what definitely is wrong nor what to do about it. That’s where we come in; Crown Chrysler Dodge Jeep Ram Greensboro provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Extremely Qualified Service technological.

Check Engine Light Service 2014 Ram 2500

What do you do when you’re driving along in your Ram 2500 and rapidly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Ram owners, your heart sinks a little because you have little idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the value of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2014 Ram 2500 checked as soon as conceivable. Ignoring that warning could end up causing dominant damage to expensive engine components.

When your 2014 Ram 2500's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the computerized control system that it can’t factual, a computer turns on your check engine light. This amber or yellow light is typically labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is learn with an electronic investigate tool that is used by our Ram auto repair technicians at Crown Chrysler Dodge Jeep Ram Greensboro. There are also a number of relatively equitable code readers that are designed for do-it-yourselfers, should you select that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced persuasive to mean the issue and repair it.

How much does it cost to get the engine light checked?

The average cost for a check engine light diagnosis & testing is commonly between $88 and $111. The good news, Crown Chrysler Dodge Jeep Ram Greensboro offers complimentary multi-point inspections and free diagnostics, in most cases, to assist choose the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not appropriately tightened to a more rigorous failure like a destructive catalytic converter or a problem with one of the car's oxygen sensors, so it good to get the tolerable code reading and diagnosis.

2014 Ram 2500 Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard suddenly illuminates, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also accepted as the OBD (on-board computer diagnostic system) in your 2500. There are hundreds of distinctive codes that your check engine light can represent. While that sounds daunting, with a little patience, tackling cooperative diagnostics will give you cooperative knowledge about your vehicle and will also allow that Check Engine Light to do what it is surely supposed to do: be your guide. Unfortunately, definite and helpful vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of likely OBD codes, there are also hundreds of likely reasons for the light, including:

  • Transmission issues
  • Ignition system faults
  • Computer output circuit issues
  • Loose Gas Cap or Missing Gas Cap
  • Emissions controls issues
  • Old Battery
  • O2 Sensor
  • Fuel and air metering systems problems
  • Bad Spark Plugs

This is why it is vivid for someone who does not have a lot of automotive knowledge to not assume what a code means. If the engine light comes on due to a adequate concern, you risk bad your car further by not repairing the issue right away. Call Crown Chrysler Dodge Jeep Ram Greensboro at 3368951348 today or schedule your check engine light service online today! When your check engine light comes on, you should get it checked out quickly by a certified Ram mechanic.

What could cause the check engine light to come on in a 2014 Ram 2500?

When your check engine light comes on, this could be as conspicuous as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a strict problem that could cause strict break to your engine and come with a great repair bill. Depending on your make and model, the check engine light will illuminate or blink. A normal glow frequently means something less strict but a shining check engine light indicates that your vehicle’s engine is in strict trouble and service is imperative quickly. If your check engine light is shining in your 2014 Ram 2500, we tremendously illustrate not to drive the vehicle and schedule Ram service today. Below is a list of the most accepted reasons your check engine light can come on:

  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2014 Ram 2500’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is commonly caused by neglected maintenance, which is why Crown Chrysler Dodge Jeep Ram Greensboro offers a complimentary multi-point inspection with every Ram service. If you have an issue with your catalytic converter and don't get it serviced, your 2014 Ram 2500 will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause added problems from overheating.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, admitted as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less realistic when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2014 Ram 2500's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to determine the right mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • One of the most contemporary and countless cause is that your 2014 Ram 2500 gas cap is loose, damaged or missing. The gas cap for your 2014 Ram 2500 serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is old or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't pricey. If your check engine light turns on immediately after you put gas in your 2014 Ram 2500, first thing you should check is to make hopeful the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or added item can wreak havoc on your 2014 Ram 2500 if it’s not installed accurately. These aftermarket parts and accessories can discard the battery, trigger the check engine light, or even prevent the vehicle from starting. If these issues sound familiar, bring your 2500 to Ram and have our team of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, chiefly aftermarket parts and accessories, or using OEM parts first place might price a little bit more but could save you money from having to get poor work and damage caused by poor installation work corrected.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Ram 2500 is what determines how much fuel is needed to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to bold changes, like altitude. If your Ram 2500 is having trouble starting, idling rough or has a sudden change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • The battery is low or dead. The battery in your 2014 Ram 2500 is every extraordinary. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a few decades ago, and they don't really require maintenance. The price of a new one depends on the type of Ram you drive, but check our current service coupons and specials.
  • New Spark Plugs or Plug Wires are needed for your 2014 Ram 2500. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or old, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, major to more pricey repairs.
  • Your 2014 Ram 2500 has a vacuum leak. Every Ram 2500 has a vacuum system that performs a wide collection of functions. The vacuum system also helps lower damaging emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, chiefly if they’re exposed to important heat or extreme bitter.

2014 Ram 2500 Check Engine Light

If the check engine light in your 2014 Ram 2500 starts flashing, that means that the problem needs prompt attention and your Ram should be brought in shortly. A flashing light indicates that the problem is active and if not taken care of shortly may result in major damage to the car. This blinking light usually expresses a scrupulous engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can promptly boost the temperature of the catalytic converter to a point where damage is probable, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can absolutely be the cause. A bad, former or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very expensive repair. If your check engine light is flashing, please contact our team of automotive advisors at Crown Chrysler Dodge Jeep Ram Greensboro urgently by calling 3368951348.

Is it safe to drive your 2014 Ram 2500 with the check engine light on?

This question is not incredibly commonplace because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to travel to work. This is commonly indicated by a dependable glow of the check engine light. If you notice a difference in the performance of the automobile, it could be an indication of a more unhealthy problem. If the check engine light is flashing, this means that there is a unhealthy issue and it is recommended to service your Ram 2500 hastily. Call the experts at Crown Chrysler Dodge Jeep Ram Greensboro by dialing 3368951348 so you can describe the issues. Or reduce your speed and deliver your 2014 Ram to our certified mechanics as soon as potential.

What Does the Check Engine Light Mean?

One of the most typically misunderstood lights or indicators in your 2014 Ram 2500 is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few odd ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your 2014 Ram 2500. Some of these include controlling engine speed, ignition timing, shifting automatic transmissions and implementing stability control, just to name a few. With that being said, the check engine light can mean a assortment of different things. It can be as plain as your gas cap being loose or as perilous as engine knocking. If your check engine light is on in your 2014 Ram 2500, contact Crown Chrysler Dodge Jeep Ram Greensboro. Our Ram service department can help you find out what code is turning your check engine light on or analyze why your check engine light is flashing. Contact Crown Chrysler Dodge Jeep Ram Greensboro today!

How many miles can you drive with the check engine light?

The safest bet is to decipher the code and then plan your strategy accordingly. If you check engine light is flashing, we advocate that you pull over and contact Crown Chrysler Dodge Jeep Ram Greensboro to help suggest if your vehicle is safe to drive in or if we advocate a tow truck. Since each check engine code has its own level of severity, it is difficult to predict how innumerable miles you can drive with the warning light on. It could be anything from a bad sensor to plug wires needing to be changed.