Please wait while the page loads...

Will the check engine light reset itself?

The check engine light on your 2016 Chrysler Town and Country will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going functional, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2016 Chrysler Town and Country light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to bring it in to Crown Chrysler Dodge Jeep Ram Greensboro so the light and code can be double-checked and reset.

2016 Chrysler Town and Country Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard expeditiously illuminates, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just additional name for check engine light codes. These are automotive computer codes stored by the ECM, also plain as the OBD (on-board computer diagnostic system) in your Town and Country. There are hundreds of contrasting codes that your check engine light can represent. While that sounds daunting, with a little patience, tackling critical diagnostics will give you appropriate knowledge about your vehicle and will also allow that Check Engine Light to do what it is truly supposed to do: be your guide. Unfortunately, accessible and appropriate vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of potential OBD codes, there are also hundreds of potential reasons for the light, including:

  • O2 Sensor
  • Emissions controls issues
  • Old Battery
  • Bad Spark Plugs
  • Ignition system faults
  • Loose Gas Cap or Missing Gas Cap
  • Fuel and air metering systems problems
  • Transmission issues
  • Computer output circuit issues

This is why it is thrilling for someone who does not have a lot of automotive knowledge to not assume what a code means. Call Crown Chrysler Dodge Jeep Ram Greensboro at 3368951348 at this moment or schedule your check engine light service online today! When your check engine light comes on, you should get it checked out quickly by a certified Chrysler mechanic. If the engine light comes on due to a unhealthy concern, you risk damaging your car further by not repairing the issue right away.

Check Engine Light Service 2016 Chrysler Town and Country

What do you do when you’re driving along in your Chrysler Town and Country and suddenly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Chrysler owners, your heart sinks a tiny because you have tiny idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2016 Chrysler Town and Country checked as soon as convenient. Ignoring that warning could end up causing leading damage to expensive engine components.

When your 2016 Chrysler Town and Country's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t suitable, a computer turns on your check engine light. This amber or yellow light is typically labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electronic scan tool that is used by our Chrysler auto repair mechanics at Crown Chrysler Dodge Jeep Ram Greensboro. There are also a number of comparatively small code readers that are designed for do-it-yourselfers, should you choose that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an trained trained to select the issue and repair it.

2016 Chrysler Town and Country Check Engine Light Flashing

Although there are many possible causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are innumerable normal causes consisting something as pure as a loose gas cap. Distinct normal reasons for a Check Engine Light are faulty head gasket, faulty emissions control part, dirty mass airflow sensor, a malfunction with the fuel injection system, damaged oxygen sensor, or defective spark plugs to name numerous. No matter what is the root cause of the Check Engine Light, we have the Chrysler Certified Technicians and the certified service protocol to isolate the root problem and repair it as imperative to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Chrysler issue was serviced.

Every 2016 Chrysler Town and Country was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its critical systems. The sensors are continually detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light lights up telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is mistaken nor what to do about it. That’s where we come in; Crown Chrysler Dodge Jeep Ram Greensboro provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Exceptionally Qualified Service professional.

What Does the Check Engine Light Mean?

One of the most commonly misunderstood lights or indicators in your 2016 Chrysler Town and Country is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few evident ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your 2016 Chrysler Town and Country. Some of these include controlling engine speed, shifting automatic transmissions ignition timing, and implementing stability control, just to name various. With that being said, the check engine light can mean a variety of assorted things. It can be as careful as your gas cap being loose or as serious as engine knocking. If your check engine light is on in your 2016 Chrysler Town and Country, contact Crown Chrysler Dodge Jeep Ram Greensboro. Our Chrysler service department can help you learn what code is turning your check engine light on or probe why your check engine light is flashing. Contact Crown Chrysler Dodge Jeep Ram Greensboro today!

2016 Chrysler Town and Country Check Engine Light

If the check engine light in your 2016 Chrysler Town and Country starts flashing, that means that the problem needs immediate attention and your Chrysler should be brought in instantly. A flashing light hints that the problem is strict and if not taken care of instantly may result in major damage to the vehicle. This blinking light usually implies a harsh engine misfire allowing unburned fuel to be deposited into the exhaust system. There it can quickly enhance the temperature of the catalytic converter to a point where damage is possible, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can totally be the cause. A harmful, old or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very expensive repair. If your check engine light is flashing, please contact our team of automotive experts at Crown Chrysler Dodge Jeep Ram Greensboro quickly by calling 3368951348.

How much does it cost to get the engine light checked?

The check engine light warns of issues ranging from a gas cap that's not properly tightened to a more strict failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it important to get the appropriate code reading and diagnosis. The average cost for a check engine light diagnosis & testing is typically between $88 and $111. The important news, Crown Chrysler Dodge Jeep Ram Greensboro offers complimentary multi-point inspections and free diagnostics, in most cases, to help opt for the cause of your check engine light.

Is it safe to drive your 2016 Chrysler Town and Country with the check engine light on?

This question is not highly prevalent because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be steady to travel to work. This is typically indicated by a steady glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more competent problem. If the check engine light is shining, this means that there is a competent issue and it is recommended to service your Chrysler Town and Country rapidly. Call the experts at Crown Chrysler Dodge Jeep Ram Greensboro by dialing 3368951348 so you can describe the issues. Or reduce your speed and bring your 2016 Chrysler to our certified mechanics as soon as feasible.

How many miles can you drive with the check engine light?

It could be anything from a damaging sensor to plug wires needing to be replaced. If you check engine light is flashing, we suggest that you pull over and contact Crown Chrysler Dodge Jeep Ram Greensboro to help represent if your automobile is protected to drive in or if we suggest a tow truck. Since each check engine code has its own level of severity, it is difficult to predict how frequent miles you can drive with the warning light on. The safest bet is to decipher the code and then plan your strategy accordingly.

What could cause the check engine light to come on in a 2016 Chrysler Town and Country?

When your check engine light comes on, this could be as easy as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a risky problem that could cause risky damage to your engine and come with a exemplary repair bill. Depending on your make and model, the check engine light will illuminate or blink. A persistent glow constantly means something fewer risky but a glaring check engine light indicates that your vehicle’s engine is in risky trouble and service is mandatory immediately. If your check engine light is glaring in your 2016 Chrysler Town and Country, we exceptionally advise not to drive the vehicle and schedule Chrysler service today. Below is a list of the most normal reasons your check engine light can come on:

  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, known as the O2 sensor, measures the fee of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less adequate when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2016 Chrysler Town and Country's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to determine the right mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a vehicle to fail an emissions test.
  • The battery is low or dead. The battery in your 2016 Chrysler Town and Country is every vital. Without a vehicle battery, your vehicle won’t start, light up the road ahead, play the radio or charge your phone. Today’s vehicle batteries last much longer than they did a lot decades ago, and they don't strictly require maintenance. The price of a new one depends on the type of Chrysler you drive, but check our acceptable service coupons and specials.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2016 Chrysler Town and Country’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is usually caused by neglected maintenance, which is why Crown Chrysler Dodge Jeep Ram Greensboro offers a complimentary multi-point inspection with every Chrysler service. If you have an issue with your catalytic converter and don't get it repaired, your 2016 Chrysler Town and Country will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your vehicle may run at a higher temperature, too, which can cause additional problems from overheating.
  • New Spark Plugs or Plug Wires are needed for your 2016 Chrysler Town and Country. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or traditional, you will experience low performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, considerable to more costly repairs.
  • One of the most acceptable and copious cause is that your 2016 Chrysler Town and Country gas cap is loose, damaged or missing. The gas cap for your 2016 Chrysler Town and Country serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is traditional or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't costly. If your check engine light turns on instantly after you put gas in your 2016 Chrysler Town and Country, first thing you should check is to make bold the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Chrysler Town and Country is what determines how much fuel is needed to run your engine efficiently by measuring the fee of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to actual changes, like altitude. If your Chrysler Town and Country is having trouble starting, idling rough or has a brisk change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • Your 2016 Chrysler Town and Country has a vacuum leak. Every Chrysler Town and Country has a vacuum system that performs a wide variety of functions. The vacuum system also helps cut harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, excessively if they’re exposed to curious heat or extreme annoyed.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or additional item can wreak havoc on your 2016 Chrysler Town and Country if it’s not installed correctly. These aftermarket parts and accessories can drain the battery, trigger the check engine light, or even prevent the vehicle from starting. If these issues sound regular, bring your Town and Country to Chrysler and have our unit of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, excessively aftermarket parts and accessories, or using OEM parts first place might value a little bit more but could save you money from having to get low work and damage caused by low installation work corrected.