Please wait while the page loads...

What could cause the check engine light to come on in a Ram?

When your check engine light comes on, this could be as uncomplicated as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a strict problem that could cause strict damage to your engine and come with a big repair bill. Depending on your make and model, the check engine light will illuminate or blink. A correct glow consistently means something fewer strict but a shining check engine light implies that your vehicle’s engine is in strict trouble and service is imperative expeditiously. If your check engine light is shining in your Ram, we excessively advise not to drive the vehicle and schedule Ram service expeditiously. Below is a list of the most fair reasons your check engine light can come on:

  • New Spark Plugs or Plug Wires are mandatory for your Ram. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are detrimental or erstwhile, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, finest to more expensive repairs.
  • Your catalytic converter is detrimental or going detrimental. The catalytic converter is a part of your Ram ’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is mostly caused by neglected maintenance, which is why Crown Chrysler Dodge Jeep Ram Greensboro offers a complimentary multi-point inspection with every Ram service. If you have an issue with your catalytic converter and don't get it repaired, your Ram will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your automobile may run at a higher temperature, too, which can cause further problems from overheating.
  • Your Ram has a vacuum leak. Every Ram has a vacuum system that performs a wide range of functions. The vacuum system also helps cut harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, especially if they’re exposed to important heat or extreme chilly.
  • The battery is low or dead. The battery in your Ram is every curious. Without a automobile battery, your automobile won’t start, light up the road ahead, play the radio or charge your phone. Today’s automobile batteries last much longer than they did a few decades ago, and they don't really require maintenance. The rate of a new one depends on the type of Ram you drive, but check our current service coupons and specials.
  • Your O2 Sensor (Oxygen Sensor) needs to be interchanged. The Oxygen sensor, known as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less efficient when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your Ram 's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to opt for the right mixture of air and fuel that enters the cylinders in your engine. A detrimental O2 sensor can also cause a automobile to fail an emissions test.
  • One of the most affectionate and frequent cause is that your Ram gas cap is loose, damaged or missing. The gas cap for your Ram serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a detrimental fuel cap? If your gas cap is erstwhile or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on instantly after you put gas in your Ram, original thing you should check is to make convinced the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or further item can wreak havoc on your Ram if it’s not installed properly. These aftermarket parts and accessories can deposit the battery, trigger the check engine light, or even prevent the vehicle from starting. If these issues sound affectionate, bring your to Ram and have our team of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, especially aftermarket parts and accessories, or using OEM parts original place might cost a microscopic bit more but could save you money from having to get poor work and damage caused by poor installation work corrected.
  • Your mass airflow sensor (known as MAF) needs to be interchanged. The mass airflow sensor in your Ram is what determines how much fuel is mandatory to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to disparate changes, like altitude. If your Ram is having trouble starting, idling rough or has a hasty change in the position of the throttle pedal, this could be a sign of a detrimental mass airflow sensor.

How much does it cost to get the engine light checked?

The average cost for a check engine light diagnosis & testing is consistently between $88 and $111. The curious news, Crown Chrysler Dodge Jeep Ram Greensboro offers complimentary multi-point inspections and free diagnostics, in most cases, to assist suggest the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not accurately tightened to a more hazardous failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it curious to get the reasonable code reading and diagnosis.

Is it safe to drive your Ram with the check engine light on?

If the check engine light is blinking, this means that there is a impressive issue and it is recommended to service your Ram hastily. This question is not very straightforward because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to commute. This is typically indicated by a steady glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more exciting problem. Call the consultants at Crown Chrysler Dodge Jeep Ram Greensboro by dialing 3368951348 so you can describe the issues. Or reduce your speed and bring your Ram to our certified mechanics as soon as feasible.

Check Engine Light Service Ram

What do you do when you’re driving along in your Ram and suddenly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Ram owners, your heart sinks a little because you have little idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t hint you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your Ram checked as soon as comfortable. Ignoring that warning could end up causing considerable damage to expensive engine components.

When your Ram 's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t decent, a computer turns on your check engine light. This amber or yellow light is constantly labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is find out with an electronic analyze tool that is used by our Ram auto repair technicians at Crown Chrysler Dodge Jeep Ram Greensboro. There are also a number of relatively low-cost code readers that are designed for do-it-yourselfers, should you imply that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an trained experienced to imply the issue and repair it.

Ram Check Engine Light

If the check engine light in your Ram starts glaring, that means that the problem needs hasty attention and your Ram should be brought in swiftly. A glaring light indicates that the problem is dangerous and if not taken care of swiftly may result in major damage to the car. This blinking light usually indicates a rigorous engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can suddenly hike the temperature of the catalytic converter to a point where damage is achievable, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can precisely be the cause. A harmful, old or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a remarkably lavish repair. If your check engine light is flashing, please contact our team of automotive veterans at Crown Chrysler Dodge Jeep Ram Greensboro today by calling 3368951348.

What Does the Check Engine Light Mean?

One of the most generally misunderstood lights or indicators in your Ram is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few added ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your Ram. Some of these include shifting automatic transmissions controlling engine speed, ignition timing, and implementing stability control, just to name a few. With that being said, the check engine light can mean a differ of back-up things. It can be as normal as your gas cap being loose or as relentless as engine knocking. If your check engine light is on in your Ram, contact Crown Chrysler Dodge Jeep Ram Greensboro. Our Ram service department can help you find out what code is turning your check engine light on or observe why your check engine light is flashing. Contact Crown Chrysler Dodge Jeep Ram Greensboro today!

Ram Check Engine Light Flashing

Although there are several potential causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are several traditional causes incorporating something as marvelous as a loose gas cap. Supplemental traditional reasons for a Check Engine Light are faulty head gasket, dirty mass airflow sensor, damaged oxygen sensor, faulty emissions control part, a malfunction with the fuel injection system, or defective spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Ram Certified Technicians and the certified service protocol to isolate the root problem and repair it as essential to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Ram issue was fixed.

Every Ram was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its preeminent systems. The sensors are continually detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what entirely is incorrect nor what to do about it. That’s where we come in; Crown Chrysler Dodge Jeep Ram Greensboro provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Greatly Qualified Service competent.

Ram Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that scant light on your vehicle’s dashboard suddenly brightens, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also commonplace as the OBD (on-board computer diagnostic system) in your. There are hundreds of discrete codes that your check engine light can mean. While that sounds daunting, with a scant patience, tackling basic diagnostics will give you accessible knowledge about your car and will also allow that Check Engine Light to do what it is really supposed to do: be your guide. Unfortunately, conspicuous and helpful car symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of factual OBD codes, there are also hundreds of factual reasons for the light, including:

  • Ignition system faults
  • Emissions controls issues
  • Loose Gas Cap or Missing Gas Cap
  • Old Battery
  • Fuel and air metering systems problems
  • O2 Sensor
  • Transmission issues
  • Bad Spark Plugs
  • Computer output circuit issues

This is why it is main for someone who does not have a lot of automotive knowledge to not assume what a code means. If the engine light comes on due to a rare concern, you risk damaging your car further by not repairing the issue right away. When your check engine light comes on, you should get it checked out shortly by a certified Ram mechanic. Call Crown Chrysler Dodge Jeep Ram Greensboro at 3368951348 today or schedule your check engine light service online today!

Will the check engine light reset itself?

The check engine light on your Ram will commonly shut itself off if the issue or code that caused it to turn on is repaired. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going functional, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your Ram light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to bring it in to Crown Chrysler Dodge Jeep Ram Greensboro so the light and code can be double-checked and reset.

How many miles can you drive with the check engine light?

It could be anything from a damaging sensor to plug wires needing to be interchanged. Since all check engine code has its own level of severity, it is difficult to predict how many miles you can drive with the warning light on. The safest bet is to decipher the code and then plan your strategy accordingly. If you check engine light is flashing, we indicate that you pull over and contact Crown Chrysler Dodge Jeep Ram Greensboro to help indicate if your car is dependable to drive in or if we indicate a tow truck.